Part 7 Half a Car Wheels and back bulkhead/seat
once we have the motor mount in place and the alignment is in the right place the drive shaft extension can be slid on to the trans axle. securing the extension to the motor i drilled a 6mm hole on the drill press through the extension using a vblock clamped down. and drilled in to the motor axle by hand using the hole in the extension as a guide. this worked ok then taped it and used an m6 screw to hold them in place and that's that all good
the wheel are slid over the shaft and mocked up with the shaft collars on then the axle is cut very slowly by hand :( to the right length.
in the below Picture you can see the extension installed on the motor
the the bulk head was cut to fit and screwed in place on to 18mm square battons
the upper photo is what the bulk head and the cowl with at the front is the start of the nose cone
and this is from the back of the car
please feel free to ask any questions i
Paul
No comments:
Post a Comment